How To Put On Roll Roofing ?

by

Roll roofing and built-up roofing are the most common techniques used to cover flat roofs. Roll roofing is simply the asphalt products manufactured in the roll form. Roll roofing, sometimes referred to as rolled roofing, is less expensive than shingled roofing and takes less time to install.

Below are some steps to install the roll roofing more efficiently. It is simply a do- it- yourself project so don’t seek for the roofers. Cut a strip of material to be under- laid to a manageable size, depending on the length of your roof. This should measure approximately 3 feet in height. Lay this along the edge of the roof.

Another piece of the same measurement is now kept over the first one. This should overlap the previous laid piece by about two inches and should be fixed in place by nailing. This should go on till the time we reach the top. The same style is adopted for installing at other end also. A metal strip is also laid on the edges of the roof to rid the water from damaging the roof. This is known as drip edge and it is nailed every 6 inches.

Cut two strips from the roll roofing, each measuring 18 inches in width by the length of your roof and lay them width by the width of your roof. Apply the roofing cement around the edge of the roof. Lay the cut strips of rolled roofing along the edges of the roof so as to cover over the cement. Nail the strips down.

We now get the entire roll of the roofing system on the roof and with the help of another person holding the roll at the far end, spread the roll roofing material to horizontally cover the length of the roof.

Having laid the roll on the roof cut the extra part. Make sure you align it before nailing. Fix the sheet you just lay using the cement. This will add strength to the roof and the roofing material as well. Further nail it at the bottom and sides of the roof.

Having done, you now need to mark a line at 33 inches from the top of the first piece. Lay down another piece aligning the chalk line. Install this piece in a manner it overlaps with the first one by 3 inches. Secure it by cement and nails.

Lay a strip on the peak of the roof, centering the piece so no seam runs along the tip of the peak. Glue and nail down this piece along both sides and edges.

Scott Rodgers is a fine expert who has been authoring on roofing for a long time now. His skill has given encouragement to a host of workers, varying from White Oak Roofers (Need one?click here!) to Baldwin Park Roofers (Need one?click here!).

  

   

Recommendations For You: